Avital AviStart 6001, Руководство по установке

Страница: 13 / 28

AviStart 6001 Installation Manual - 0999
Ignition Switch Connections
NOTE: Because these wires can draw high current, we recommend that they
be soldered and shrink tubed or taped. If only one PINK wire is needed, tape
the end of the second PINK wire to prevent a short circuit. The main control
module has an 18 ga PINK wire that must be connected to the vehicle
ignition wire with one of the satellite module 14 ga wires.
Ignition #1 Ignition #2
The satellite relay module has two onboard 30-amp relays. Most vehicles have
only one ignition wire necessary to start the vehicle. Some vehicles have two
ignition wires. Make all wire connections at the ignition switch wire harness.
1. Use a voltmeter to locate the wire(s) that show +12 volts while the ignition
key is in the "ON," "CRANK" and "RUN" positions and 0 volts when the
ignition key is in the "OFF" position.
2. Connect the 18 and 14 ga PINK wires to the vehicle ignition wire.
3. If the vehicle has a second ignition wire, connect the other 14 ga wire.
Heater/AC #1 — Heater/AC #2
The satellite relay module has one onboard 30-amp relay. Most vehicles have
only one heater/AC wire. If an additional heater/AC wire is required to activate
the vehicle’s heater/AC system, follow the directions under step #5 below. Do
not use the
GRAY wire to power more than one heater/AC wire.
1. Use a voltmeter to find the wire(s) that show +12 volts when the ignition
key is in the "ON" position, 0 volts while the starter is cranking and +12
volts while running.
2. Cut this wire in half. Start the vehicle and turn the blower switch on. The
blower should not turn on.
3. Connect the GRAY wire to the heater/AC wire.
4. If the vehicle has a second heater/AC wire, connect the PINK/BLACK wire
to the second heater/AC wire.
5. Programmable ignition or heater/AC output #2– the PINK/BLACK wire can
be programmed to supply an ignition or heater/AC output. The satellite
module is factory programmed for ignition #2. To change the
PINK/BLACK wire from ignition to heater/AC, follow the procedure below.
• Open the satellite relay module (2 screws).
• Remove the jumper termial from "IGN" terminal.
• Insert the jumper terminal to the "HTR" terminal.
11