Avita NT16B, Инструкция по эксплуатации

Страница: 6 / 12

Measuring Object/Liquid Temperature
1. Press the Power button to turn the
thermometer on. All symbols on the display
will momentarily appear.
2. Ensure that the thermometer is in Object
mode; the Object symbol will be on the
display. To alternate between modes press
and release the Human/Object Mode button
until you see the desired measurement
symbol on the display.
3. Position the thermometer under 3cm (around 1 inches)
from the object.
4. Press and release the
“
Power & Measure button
”
and the
temperature reading will be displayed.
5. After about 30 seconds after use, the thermometer will
automatically beep and shut off.
9
Memory Function
Memory Recall:
You can recall up to 30 measurements currently stored in
memory to share with your physician or
trained healthcare professional.
1. When the device is on, press once briefly
on the "MEM button", then pass it again
to show the last measurement
accompanied by
“ ”
symbol.
2. The
“ ”
symbol or
“ ”
symbol will appear with each
measurement stored in memory to indicate whether a
person or object temperature was taken.
3. Each press of the same button recalls a previous
measurement, so
“ ”
then all the way to
“ ”
.
Memory Deletion:
1. Under power on status, you may keep press MEM Button
for more than 3 seconds to delete all the readings.
2. You will see "00" on display and
“
sound a beep
”
, that
mean all the memories are cleared.
3. Automatically on the 31th measurement:
when the 30 memories have been used up, any new
measurement will be recorded with “
”
and the oldest
memory deleted without you having to do anything.
Note:
All the readings will be cleared no matter record in Human
mode or Object mode.
10