Avita ADTEMP 429, Руководство пользователя

Страница: 10 / 10

Note: If the patient’s skin is covered with hair, sweat, or dirt, clean the area
and wait 10 minutes before taking a measurement.
Note: Ensure that the thermometer is held firmly during measurement and
that the patient does not move until the measurement is complete. Patient
movement can impact the measurement.
4. Press and release the
Measure button making sure not to obstruct your
view of the LED display or the buttons area.
5. Slowly move the device towards the patient’s forehead. The unit will
beep continuously and a series of dash icons forming two circles
will rotate on the display. Once the correct distance is reached
(about 1 inch or 3 cm), an amber light will flash just below the
Mode and Memory buttons. The unit will emit a short beep
(except in night mode), and the backlit display will illuminate
when the measurement is complete.
Note: If the distance of the thermometer is too far from or too close to the
patient’s forehead, the dash icons will continue to rotate and the unit will
beep (except in night mode) UNTIL the correct distance is obtained. Once the
Measure button is pressed and released, you will have 20 seconds to obtain
a temperature reading. After 20 seconds the unit returns to standby mode.
6. To repeat the process, return to step 2.
7. The thermometer automatically turns off (with a single beep) after 30
seconds of inactivity.
Note:
The device cannot be turned off manually.
Note: The Human or Object symbols will be displayed to indicate the
measurement mode that was in use for the displayed reading in memory.
3. Each press of the
Memory button will display a previous measurement
(up to 30).
10 11
To delete readings from memory:
1. Press the Measure button to power the unit on.
2. Press and hold the
Memory Button for at least 3 seconds
to delete all the readings.
3. The LCD displays "--" and the device beeps to confirm
all the memories are cleared.
Note: Once 30 measurements are in memory each new measurement will
overwrite the oldest.
Note: All the readings (Human and Object) will be cleared when deleting
readings from memory.
6.Memory Fucntion
The unit retains the last 30 readings.
To recall previous readings:
1. Press the Measure button to power the unit on.
2. Briefly press and release the
Memory button then press again to display
the last measurement accompanied by the symbol.
93-429-00 Small IFU rev 6.qxp_Layout 1 4/1/20 12:06 PM Page 10