Avision AV3600, Руководство пользователя

Страница: 11 / 63

2-4
2.2 SCSI INTERFACE DEVICE ID
When you have several devices on a SCSI chain,
you may need to adjust the SCSI ID selector
setting located on the back of the scanner. This
setting assigns a specific "device ID" to the
scanner. If the assignment conflicts with an
existing SCSI device, please select a new ID. (See
Figure 2-2)
Note: The factory setting for scanner is ID 6.
Usually, ID 0 is assigned to an internal hard disk
drive, and ID 7, ID 8 ,and ID 9 are not in actual use.
Using a suitable tool, turn the selector switch until
the arrow points to the desired ID number.
2.3 Setting SCSI Terminator
The scanner is equipped with a built-in terminator
switch on the rear of the scanner. (See Figure 2-2).
The scanner is equipped with a built-in terminator
switch on the rear of the scanner. Turn the
terminator switch on if the scanner is to be
connected to the computer as the only or the last
SCSI device. Turn the terminator switch off if the
scanner is to be located between the computer and
the other SCSI device.