Press
【
CAM2
】
,
“Addr: 002, 9600 P
-
D” will show on the screen, and
【
CAM2
】
button will light up. You
now have control of the camera.
2.
IP VISCA (via Ethernet port)
To properly set up the connection, you need to make sure that the camera supports IP VISCA and the
keyboard is within the same LAN as the camera.
•
CAMERA:
Before setting up the connection on the keyboard, you’ll need to get some information of your camera:
Camera IP Address
: take AV-1280 as an example, its IP address is 192.168.5.163.
Subnet mask:
255.255.255.0 (AV-1280)
Gateway:
192.168.5.1 (AV-1280)
UDP Port:
1259(AV-1280)
*Please refer the table on Page.5 for all AViPAS cameras port information.
•
KEYBOARD:
a.
Set up controller IP:
Press
【
SETUP
】
-> push the joystick down
to select the submenu, until “
Setup 05/08
” shows on the
screen for
Mode
selection;
Push the joystick rightward to choose the protocol: “
IP VISCA
”
-> press the button on the joystick to
enter, or press
【
ENTER
】
;
Press
【
SETUP
】
again -> push the joystick down to s
elect the submenu, until “
Setup 02/10
” shows on
the screen for
IP
selection-
> push the joystick to the right until it shows “
IP: Static
”
-> press
【
ENTER
】
;
Use the keyboard to set the IP address of the controller: (Connected with AV-1280 series)
192.168.5.100
-> press
【
ENTER
】
to go to the next section;
* Keep the first 3 sections (192.168.5) the same as the connected camera, while the last section different. In this
case, camera: 192.168.5.163; controller: 192.168.5.100.
*If there’re less than 3 digits in the section, push the joystick to the right to go to the next section.
Subnet mask: keep the same as the connected camera.
255.255.255.0
-> press
【
ENTER
】
to go to the
next section;
Gateway: keep the same as the connected camera.
192.168.5.1
-> press
【
ENTER
】
