The eight-channel External HA screen shows all controllable parameters.
Only active Pro64 channels on connected 6416m preamps can be edited.
Remember that the HPF parameters can only be set to on/off; the high pass
filter cutoff frequency parameter does not apply to the 6416m Mic Input
Module. The device type will always be displayed as “AD8HR” as Pro64’s
m‑control is emulating this protocol. All changes made from this screen are
instantly transmitted to active 6416m channels on the Pro64 network.
Assigning Remote Preamp Channels to the LS9
Faders
Each mixer channel on an LS9 can be configured to use any of the console’s
available audio resources, including the built‑in mic/line inputs on the LS9
rear panel and channels coming into the console via MY expansion slots.
The default routings for the LS9‑16 have channels 1‑16 patched to receive
audio from the rear‑panel jacks; audio from MY expansion slots defaults to
channels 17 and above. The LS9‑32 has the first 32 mixer channels patched to
receive audio from the rear panel input jacks, with channels 33‑64 defaulting
to the two MY slots.
68
m
-
Control
