45
Temperature setting
A
ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
B
Decrease temperature of 1 degree Celsius or Fahrenheit.
C
Raise temperature of 1 degree Celsius or Fahrenheit.
D
Display shows upper zone temperature at its setting. 5 seconds later, it will automatically
turn to actual temperature inside the wine cellar till reaching setting one.
E
Temperature display in Celsius.
F
Temperature display in Fahrenheit.
G
Display shows lower zone temperature at its setting. 5 seconds later it will automatically
turn to actual temperature inside the wine cellar till reaching setting one.
H
Compartment selecting switch (lower or upper one). Once the compartment has been
selected, it will show setting temperature as flash, 5 seconds later automatically turn to
inner cabinet actual temperature till it reaches the setting one.
I
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
Celsius or Fahrenheit.
J
Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone
is adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But
for optimal performance, once one zone is set at 12ºC, we suggest another setting for the other
zone with 3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature
difference between both compartments is 10°C. Always set cooler temperature in the upper
compartment and warmer temperature in the lower compartment (example: 5°C upper and 15°C
lower).
You can touch key “+” (C) and key “-” (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked for upper zone and for lower zone.
When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the “+” (C) and “-” (B) mark once of each compartment to set the desired
temperature.
The temperature will increase by 1°C or 1ºF if you touch the “+” (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the “-” (B) mark once.
