After you click
Apply Changes
, allow the system to reboot when the following message is displayed:
Applying changes may reboot cameras. Do you want to continue?
As the settings are implemented, this message is displayed:
Resetting camera power settings.
This will take 90 seconds to complete.
The web interface automatically refreshes the screen and displays the updated settings after it finishes applying
the new power settings.
PoE Status
Tip:
If a device is disconnected then reconnected to the recorder, you may need to refresh this page to view
the latest status and budget values.
The POE page displays a status for each port in the Status column. Statuses include the following:
l
No device connected
— there is no Ethernet cable connected to the port.
l
Operating normally
— a PoE device is connected to the port and is operating normally.
l
Unpowered device
— a device is using the port for a network connection only.
l
Port is powered off
— a PoE device is connected to the port but is not receiving power. This status
typically occurs when the port is overcurrent, device is requesting more power than budgeted, etc.
At the bottom of the POE page is the overall power budget status. The status typically says:
#W Currently Budgeted (note: The total budget cannot support more than 64W. Devices will turn
off automatically when exceeded. To reduce consumption, turn off POE+ for one or more ports, or
use cameras that require less than budgeted amount.)
When the message is
red
, the PoE switch component is over the power budget and one or more devices may
have powered down from insufficient power.
Device Log
The Device Log page allows you to view the recorder system logs. The logs are typically requested by Avigilon
Technical Support to help resolve an issue.
By default, the page displays 100 warning messages from the ACC Server Logs.
You can filter the logs to display the information that you need:
1. In the
Type:
drop down list, select the type of application log that you need. The options are:
o
ACC Server Logs
o
Fcp Logs
o
System Logs
o
Boot Logs
o
Nginx Error Logs — web interface logs
2. In the
Minimum Log Level:
drop down list, select the minimum severity of the log messages that you want
to see. The options are:
PoE Status
19
