Avigilon ES-HD-HWS-SM, Инструкция по эксплуатации

Страница: 4 / 40

EN - English - Instructions manual
4 ES-HD-HWS-SM
2.2 Brackets for internal cable
channel
1. Fix the cable glands in the direction shown
(01), taking care to tighten the nuts properly
(02).
01
02
2. Pass the wires and the cables through the
bracket into the housing; these cables should
be locked by the cable glands (01).
3. Secure the housing to the bracket using
the 4 screws provided with the bracket.
Add some threadlocker glue on the screw (as
LOCTITE 243). The cable glands are suitable
for cables with a diameter comprised between
5 and 10mm.
2.3 Cabling
Make sure your external power source
matches the camera’s power requirements
.
2.3.1 Camera board (if present)
1. Connect the camera power cable to
the connector marked OUT (01) on
the board following the pictograms.
Power Camera
02 01
2. Connect the external power cable to the
connector marked IN (02) on the board.
3. Connect the power cable as shown.
5mm
Make sure the earth conductor is at least
10mm longer than the others. The power
supply cable conductors must be tied up next
to the terminal.
2.4 Closing the housing
1. Take the dessicant salt bag out of its trasparent
pack and insert it into the housing.