Avigilon 8.0MP-HD-DOME-180, Руководство по установке, Страница: 17 / 139

10
EnglishEnglish
The connection status LEDs show the progress in connecting to the
server and are described in the following table. By default, the
connection status LED shuts off after the dome camera has been
connected to a server
IP Address Selection
Once connected to a network, the dome camera will attempt to locate
and obtain an IP address from a DHCP server. If this fails, an IP
address will be selected using Zeroconf (APIPA).
If the IP address is set using Zeroconf, the IP address will be in the
169.254.* subnet. A static IP address can be set from the Avigilon
Control Center software, consult the software user guide for details.
Table:Connection Status LED States
Connection
State
Connection
Status LED
Description
No Link Off Not physically connected to any
network device
Obtaining IP
Address One short
flash every
second Attempting to obtain an IP address
Connecting to
a server Two short
flashes every
second An IP address has been obtained
and is attempting to connect to the
server
Upgrading
Firmware Two short
flashes and
one long flash
every second Updating the firmware
Connected On Connected to the server