1. Attach the lanyard on the mounting adapter to the anchor on the camera base.
2. Pull the required Ethernet cable through the cable entry hole on the camera base.
3. Install the grommet into the cable entry hole on the camera base.
Make sure the grommet flange is securely seated on the inside and outside of the cable entry hole.
4. Connect the cable to the Ethernet port.
The Link LED will turn on once a network link has been established.
5. Align the large orange arrow on the camera base to the side cable entry hole on the mounting adapter
then press the camera base into the mounting adapter. The camera base clicks into place and is held
securely.
(Optional) Using the USB Wi-Fi Adapter
If you have a USB Wi-Fi Adapter (H4-AC-WIFI), attach it to the camera's micro USB port to access the camera's
mobile web interface.
After you connect to the Wi-Fi signal broadcast by the adapter, you can access the mobile web interface from
any mobile device using the following address:
http://camera.lan
(Optional) Using the USB Wi-Fi Adapter
13
