1. Make sure the safety lanyard is connected to the PTZ dome camera.
2. If there are external input or output devices that need to be connected to the camera (for example: door
contacts, relays, analog video, speakers, etc.), connect the devices to the camera I/O connector cable.
3. Connect power using one of the following methods:
l
Power over Ethernet (PoE) Plus IEEE 802.3at Class 4 — Connect a PoE Plus compliant injector or
switch to the Ethernet network cable.
l
60 W PoE Injector (POE-INJ2-60W) — Connect an Ethernet network cable to the injector.
l
External Power — Connect an auxiliary power source that supports up to 60 W.
For more information, see
4. Connect a network cable to the Ethernet port (RJ-45 connector).
The Link LED will turn on once a network link has been established.
5. Check that the Connection Status LED indicates the correct state. For more information, see
Securing the PTZ Dome Camera
After the cable connections have been made, secure the PTZ dome camera to the mount.
1. Attach the dome to the NPT adapter.
a. Push the PTZ dome camera into the 1 1/2” NPT mount adapter.
NOTE:
Be careful not to trap any cables between the dome camera housing and the mount
adapter.
b. Once the dome is aligned to the NPT adapter, turn the dome until it locks into place.
2. Use the Torx key provided with the dome camera to tighten the screws in the mount adapter.
Adjust the NPT adapter as needed to reach all the screws.
Securing the PTZ Dome Camera
11
