7
CONNECTIONS
The Reference Three allows for either bi
-
wiring or bi
-
amping. This means that you need a connection
from you amplifier to each terminal on the back of the loudspeaker. We recommend using a bi
-
wired
configuration whenever possible
•
Either Banana/4mm or Spade connectors may be used.
•
If would require to use a conventional, single wired connection, you
will need to create a short set of ‘jumper’ connections that join the L.F. negative to H.F. negative
and the L.F. positive to the H.F. positive.
•
The banana/4mm connectors from the amplifier simply need to be pushed into the central hole of
each connector.
•
To connect a spade connector, simply loosen each connector, by rotating the clear cap
anti
-
clockwise, then insert the spade in the slot, from below—no more than hand tightening is
required. Excess force could damage the connector.
CABLE CHOICE
Whilst AVID do manufacture a range of loudspeaker cables, designed to match the performance of our
loudspeakers, our loudspeakers will function with most cable types. When choosing a cable, it is best to
remember the following:
•
These speakers are capable of handling very high powers. To attain these powers a low
-
resistance
connection is necessary—a cable with a large cross
-
sectional area is highly recommended.
•
To further reduce the DC resistance of the loudspeaker cable, it is recommended that cable lengths
should be as short as possible, and of equal length.
•
The DC resistance of connections at either end of the cable is equally important—ensure all
connections are clean and secure.
