4 Display Messages
The reader's display can show many different status and mode messages in addition to
microchip ID numbers. Here is a summary of the various messages which you might see
while using your reader.
Message
Timeout
Description
Battery Low
None
The battery voltage is very low. Please turn off the
reader power and remove the weak battery
immediately to prevent battery leakage, and
replace it with a fresh battery.
Connected
NNN
3 sec.
The reader has successfully connected with a
Bluetooth device in NONE, ENTR, or TAB modes.
NNN
is the connection state code.
Disconnect
NNNN
3 sec.
The reader has disconnected from a Bluetooth
device.
NNNN
is the disconnection code.
No ID Found
None
The reader did not find a microchip before the
read button was released.
Pair again
3 sec.
The existing pairing data was invalid. The reader
automatically returns to OFF mode. The user may
initiate pairing again by switching to PAIR mode.
Pair failed
NNNN
3 sec.
The Bluetooth device cannot connect to the
reader. The failure code
NNNN
indicates the
problem with the Bluetooth device,
e.g.
device has
outdated pairing information.
Paired
NNN
None
The reader has successfully paired with a
Bluetooth device in PAIR mode.
NNN
is the pairing
state code.
Pairing outdated
3 sec.
The reader rejected pairing request. The pairing
information on the rejected device is outdated.
Pairing removed
3 sec.
The PAIR mode timed out after 2 minutes. The
existing pairing information on the reader has
been removed.
Ready to read
3 sec.
The reader can accept more tag reads for
Bluetooth keyboard entries.
Wait for ready
3 sec.
The Bluetooth keyboard entry queue is full. Wait
for the
Ready to read
message before
scanning another tag. The reader will display
Ready to read
when it is ready to read and
transfer another tag.
Avid Wand Reader-B User's Manual: 2017-07-14 Release
Copyright © 2017 Avid Identification Systems, Inc.
Page 9 of 12
