Avid Technology SR2400, Руководство по установке, Страница: 76 / 90

Appendix C Using the Product Recovery CD-ROM
76
t
If the version number in the dialog box is later than the version
number you wrote down, you must reinstall the ATTO driver. Follow
the ATTO driver installation instructions in
“Updating the ATTO
Driver and Phantom Device” on page 76 .
t
If the version number in the dialog box is the same or earlier than the
version number you wrote down, you do not need to reinstall the
ATTO driver.
To check the Alacritech drivers:
1. Locate the Alacritech driver version number you wrote down at the end of
the operating system recovery procedure.
2. Locate the MediaNetwork CD-ROM for the version of MediaNetwork
software you are going to reinstall.
3. Insert the MediaNetwork CD-ROM into the PortServer CD-ROM drive.
4. Navigate to Drivers_Firmware\NetworkAdapters\Alacritech\w2k.
5. Right-click the atcp.sys file, and select Properties. The atcp.sys Properties
dialog box opens.
6. Click the Version tab. The version information appears.
7. Compare the “File version” in the dialog box to the version you wrote
down at the end of the operating system recovery procedure, and do one
of the following:
t
If the version number in the dialog box is later than the version
number you wrote down, you must reinstall the Alacritech driver.
Follow the Alacritech driver installation instructions in
“Reinstalling
the Alacritech Driver” on page 79 .
t
If the version number in the dialog box is the same or earlier than the
version number you wrote down, you do not need to reinstall the
Alacritech driver.
Updating the ATTO Driver and Phantom Device
When you reinstall the ATTO driver, you need to also reinstall the ATTO
Phantom Device.