Avid Technology SR2400, Руководство по установке, Страница: 73 / 90

Configuring the PortServer System Using Windows 2000 Setup
73
t
Press Y to continue. The Norton Ghost
®
screen appears showing the
progress of the operating system recovery. This takes approximately
10 minutes. Continue with step 13.
t
Press N to quit the recovery.
13. A screen appears informing you that the recovery is complete. It also
shows the versions of the ATTO
™
driver and the Alacritech
®
driver that
were installed.
14. Write down the versions of the ATTO driver and the Alacritech driver
that appear in the message. You will need these version numbers later.
15. Remove the Avid PortServer Product Recovery CD-ROM from the
PortServer CD-ROM drive.
16. Press Ctrl+Alt+Delete to reboot the PortServer system and start the new
Windows 2000 operating system.
The Windows 2000 operating system recovery is complete. You need to
configure the operating system as described in the following section.
Configuring the PortServer System Using
Windows 2000 Setup
After you recover the Windows 2000 operating system, it runs the Windows
2000 Setup utility to set several Windows operating system parameters. You’ll
need to have the Windows software kit available when you run the utility. It
contains the Windows license number you need to type in as part of the
configuration.
To set up the Windows operating system:
1. After the PortServer system reboots, the Windows 2000 Setup utility
starts and the Windows 2000 Server Setup dialog box opens showing the
License Agreement screen.
2. Click the “I accept the agreement” radio button to accept the license.
3. Click Next. The Regional Settings screen appears.
t
If you are outside the United States, customize the system and locale
settings, and the keyboard for your location.
t
If you are in the United States, continue.