Avid Technology MV3000 DELTA, Техническое руководство

Страница: 51 / 188

T1689 Technical Manual Rev 07 Specification
MV3000 Air Cooled DELTA DELTA Rectifier Module
Page 51
Cabling of phase power terminals for GDR721, 872 & 1168
When cabling to the phase terminals of these rectifiers the centre terminal may be rotated through 180° to
increase the clearance distance between the cable crimp and the adjacent terminal.
Figure 2–19. – Rotation of Centre Phase Terminal for Cable Connection
Terminations
Module Type Number of
Terminals
Description of termination
3-phase Supply
GDR391 3 M10 stud for cable ring crimp (use M10 or 3/8 in crimp)
GDR633 6 M10 stud for cable ring crimp (use M10 or 3/8 in crimp)
GDR721 3 50 x 6.3 (2 x ¼ in) busbar with 2 x 10.5 mm holes
GDR872 3 63 x 6.3 (2½ x ¼ in) busbar with 2 x 10.5 mm holes
GDR1168 6 50 x 6.3 (2 x ¼ in) busbar with 2 x 10.5 mm holes
D.C. Output
GDR391 2 M10 insert for cable ring crimp (use M10 or 3/8 in crimp)
GDR633 4 M10 insert for cable ring crimp (use M10 or 3/8 in crimp)
GDR721 2 63 x 6.3 (2½ x ¼ in) busbar with 2 x M10 threaded inserts / studs
for cable ring crimps (use M10 or 3/8 in crimp)
GDR872 2 80 x 6.3 (3 x ¼ in) busbar with 4 x M10 threaded inserts for cable
ring crimps (use M10 or 3/8 in crimp)
GDR1168 4 63 x 6.3 (2½ x ¼ in) busbar with 2 x M10 threaded inserts / studs
for cable ring crimps (use M10 or 3/8 in crimp)
Table 2–23. – Terminations for 3-Phase Supply & DC Output
The a.c. terminals are suitable for a maximum of 2 x 150 mm 2 cables (2 x 300 MCM in North America).
To achieve the full current rating of the product, it may be necessary to use high temperature cable.
See Section 3 – Drive (CDM) Design
NOTE: Do not allow the temperature of the cable to exceed 125°C (257°F).
The d.c. positive terminals are suitable for a maximum size of busbar at 76 mm x 6.3 mm wide (= 3 in x ¼ in).
The d.c. negative terminals are suitable for a maximum size of busbar at 140 mm x 6.3 mm wide (
≈
5½ in x
¼ in). Ratings and sizes of busbars are application dependent.