Avid Technology AirSpeed series, Инструкция по установке и эксплуатации

Страница: 62 / 282

2 Installing the Hardware and Setting Up Your System
62
Connecting SDI Video Output Cables (for DNxHD Models)
The SDI Video Output connections are marked on the rear of the AirSpeed Multi Stream
DNxHD. The following procedure describes which connector to use. To find the exact
location, see
“Video/LTC Connections (DNxHD Model)” on page 44 .
n
When an AirSpeed Multi Stream channel is in Record mode, the signal present at the video
input will display on the corresponding video output.
The following illustration shows the location of the SDI OUT video connectors on the rear
of the AirSpeed Multi Stream DNxHD chassis.
To connect SDI video output cables on the DNxHD model chassis:
1. Ensure that you have the proper SDI video (75 ohm-rated) interface coaxial cables
available.
2. Connect the SDI output signal to an outgoing SDI output (one of the four labelled
OUT1-4) for AirSpeed Multi Stream DNxHD models.
Up to four SDI outputs are available for sending SDI signals out to your other devices.
3. Connect the other end of all SDI output cables to your devices that are receiving the
output signal from the AirSpeed Multi Stream DNxHD.
1 2 3 4
IN
1
2
EXPANSION
PORT 1
EXPANSION
PORT 2
USB
CONSOLE
VGA
SERIAL
ETHERNET 1 2 3 4
1 2 3 4
5 6 7 8
OUT
REF
IN/THRU
LTC
IN/THRU
Broadcast Devices