Avid Technology AirSpeed series, Инструкция по установке и эксплуатации

Страница: 227 / 282

Reimaging Your System
227
Loading the Windows XPE Restore Image
This topic contains information on how to load a Windows XP Embedded (XPE) restore
image on your AirSpeed Multi Stream system.
To load the Windows XPE Restore image:
1. Unlatch, (but do not remove) the four media drives from the chassis.
2. Insert the USB Flash Drive (UFD) into one of the USB ports on the back of the
AirSpeed Multi Stream system.
3. Restart the AirSpeed Multi Stream.
The system will begin to start up.
4. When prompted, press F2 during startup to enter the system BIOS.
The BIOS setting menu opens.
5. Navigate to the Hard Drive BBS Priorities menu, and press Enter. Do the following:
a. Highlight Boot Option # 1 (SATA: Name of your hard drive ).
b. Change it to the UFD (such as KingstonDataTraveler), and press Enter.
c. Highlight Boot Option # 2.
d. Change it to SATA: Name of your hard drive, and press Enter.
e. Press ESC to exit the BBS Priorities Menu.
6. Ensure that the Boot Options Priorities menu shows the following:
t
Boot Option #1 displays the UFD that you changed to on the Hard Drive BBS
Priorities menu.
t
Boot Option #2 displays the SATA drive that you changed to on the Hard Drive
BBS Priorities menu.
‰
(Option) If you are using Avid iNEWS Command or Capture Manager to control AirSpeed
Multi Stream, you need to install the AirSpeed Multi Stream Device Service (for Command
and Capture Manager), as described in the topic
“(Option) Installing the AirSpeed Multi
Stream Device Service” on page 86 .
‰
Configure your AirSpeed Multi Stream, as described in “Configuring the Software” on page
81 .
IMPORTANT : Before creating a new database in AirSpeed Multi Stream, make sure you
delete all old databases from the AirSpeed Multi Stream.
‰
Rebuild your database as described in the topic “Rebuilding a Database” on page 233 .