Network Override Kit
3
Part 0130-01171-01 Rev. A
Installation
Installation
c
Be sure the power supply is disconnected before you begin.
To install the ST-LCR 2 relay:
1. Find a convenient place to locate the ST-LCR 2 Logic-Controlled
Relay, illustrated in Figure 1. The relay should be near the termina-
tion of the cable from the Performer Tally/Override connector,
and it must be within 5 feet of an electrical outlet.
Figure 1
ST-LCR1/2 Logic Controlled Relay
2. Connect a wire from pin 14 (+5 VDC), from the Tally/Override
cable or its punchdown position, to the normally open position on
the Þrst set of contacts, as shown in Figure 2.
3. Connect a wire from the correct override position (see Table 1),
from the Tally/Override cable or its punchdown position, to the
armature connector of the same set of contacts used in step 2.
