2
Turn the Base Assembly back over and locate the Front Panel (B.) Slide the Front
Panel onto pegs of one side of the Base assembly.
3
Locate the Back Panel (C.) Slide the Back Panel onto the pegs on opposite side
of the Base Assembly.
4
Locate the Side Panel with 2 food doors (D). Determine which side would be best
for you to have the 2 food doors. Slide the Side Panel over the metal tab at the bottom
of the Front Panel and Back Panel.
5
Insert and push the tabs at the top of the Side Panel into the sleeves on the top of
the Front and Back Panels.
6
Repeat Step 4 & 5 with the opposite Side Panel (E.)
7
Locate the Top Panel (F.) Carefully lower the pegs on the Top Panel into the holes
in the corners of the cage assembly. Push down making sure the Top Panel is totally
insert, locking all the panels together.
8
Locate the Bottom Grid (G) and the Bottom Pan (H.) The Pan can be inserted in
two different positions, depending on the use of the Bottom Grid.
Bottom Grid will be used:
Slide the Bottom Grid in the rails just below the
front door. Slide the Bottom Pan immediately under the Bottom Grid.
Bottom Grid won’t be used:
For storage purposes, slide the Bottom Grid in
the lower rails. Slide the Bottom Pan in the rails above the Bottom Grid.
9
Open the feed doors on the side panels, and insert the Cup Holders (M) into the
tubes on the inside of the doors.
10
Locate the Feed Cups (L) and insert one into each of the Cup Holders.
11
Locate the Latch assembly components. (Note: If the knob is screwed into the
latch bar, unscrew the knob.) Place a spring over the round end of the latch bar. Insert
the latch bar, with the threaded hole facing outward, into the lock sleeve on the cage door.
Insert it so the round end protrudes through the opposite end of the sleeve.
12
Push the latch in a bit so the threaded hole shows through the “key hole” in the
front of the sleeve. Screw the knob into the latch bar.
Note: Be sure the latch is fully secured when locking doors. For added security, when
the latch knob is in the locked position, screw the knob tight. This will lock it in the “key
hole.” Unscrew the knob enough to clear the sleeve to unlock.
13
Locate the Long Skirts (I) and insert the pegs into the metal sleeves attached to the
lower part of the cage.
14
Locate the Short Skirts (J) and nest them with flat tabs into the Long Skirts.
15
Locate the Playtop Base (P). Slide the Playtop Pan (Q) out of the Base and remove
all packing materials.
