3. OPERATING YOUR APPLIANCE (continued)
Proper operation of the appliance is guaranteed only if the following conditions are met:
The room temperature where the appliance is located conforms to class stated on rating label.
Maximum ambient relative humidity: RH75%.
The appliance must be placed at a sufficient distance from heat sources (e.g., ovens, central
heating, direct sunlight, etc.).
The appliance must be located in such a place that it is protected against the effects of weather.
Regular maintenance is performed according to the instructions in this user’s manual.
The ventilation openings on the appliance must not be covered.
Correct installation (e.g. leveling, capacity corresponds to the specifications on the rating label).
REVERSING THE DOOR
IMPORTANT: THIS OPERATION REQUIRES AT LEAST TWO (2) PERSONS.
INSTRUCTIONS
1.
Open the door at a 90ᵒ angle, take out two screws from lower door axis (#3) and pull out door.
2.
Set the door aside in a safe place and take out decorative nail (#7) from top of door frame. Remove
the two screws (#4) at bottom and take out the Extrusion-board of lamp switch (#5). Install the
Extrusion-board of lamp switch (#5) at top of door frame and use spare decorative nails to block the
hole at top of door frame.
3.
Unscrew the three screws (#8) from top right hinge (#6) and take out the right top hinge.
4.
Remove the decorative nails (#10) from left top of cabinet and install the spare top hinge (#9) at left
top of cabinet using the three screws.
5.
Install spare lower hinge (#11) onto left lower cabinet.
6.
Rotate the door 180ᵒ then re-install it in the same way it was removed, making sure it is aligned
properly.
7.
Block the hole at right top of cabinet with the spare decorative nail.
26
