
When reusing against non-toxic or common particles, close the filter inlet and
outlet with the covers to prevent polluting or contaminating the environment.
Then, thoroughly clean the filter and store it in a suitable location.
When using the filter against harmful microorganisms, highly toxic or radioactive
particles, it is recommended to replace the filter after every use in order to
completely reduce the risk of secondary contamination of clean uncontaminated
spaces. In the case of protection against biological agents, the following
procedure is recommended:
After use, treat the outer section of the filter and the protective face unit with
disinfectants. Then, disinfect both covers. Apply the filter inlet cover so that the
filter is tightly closed. Next, remove the filter from the protective instrument.
Disinfect the inner and outer parts of the thread and screw the cover back on.
The filter may be thermally disinfected by exposure to
75 °C for 60 minutes,
whereas the total duration of the accumulated thermal cycles should not exceed
12 hours.
The surface of the filter may be disinfected with common disinfectants used in
healthcare.
Warranty: The manufacturer guarantees full functional properties of the filter in
undamaged packaging and in compliance with storage conditions. Improper
storage may result in reduction of the resistance duration of the filter or cause
irreversible damage.
Long-term storage conditions: temperature: -
5 ° C
-
+30 ° C; relative humidity: up
to 80%; the protective packaging must be intact.
Maintenance: The filter used cannot be regenerated in any way. When reusing,
close the filter inlet and outlet with the covers to prevent polluting or
contaminating the environment. Then, thoroughly clean the filter, place it in the
original packaging and store it in a suitable location.
In case of any queries, contact the filter manufacturer or supplier.
Further documentation on the filter, including a copy of the certificate and a
declaration of conformity, can be found on the manufacturer’s website
Manufacturer: AVEC CHEM s.r.o., Chrudimská 1555, 535 01 Přelouč, Czech
Republic