3
Make sure all corner base plates are fully and rigidly supported. If neces-
sary, use metal shims to ensure a good, level support.
Loosen all check bolts - 4 per module
Remove the nuts from the hold down bolts; lower the bolts; then, replace the
nuts on the bolts, so they remain on the holding block on the frame.
Adjust the check bolts to a maximum of 3/16" clearance. Refer to Figure 3.
Figure 3
Checkbolts
Install the optional bulkheads on each end of the scale.
If the bulkheads are from Weigh-Tronix, use (4) 3/4 - 10 x 2 1/2" bolts, bevel
washers, and nuts supplied by Weigh-Tronix. Refer to Figure 4.
If other than Weigh-Tronix bulkheads are used, ensure the proper clearance
between the scale platform and the bulkhead. Weigh-Tronix will not be
responsible for error caused by other bulkheads.