2
Internal Liner Take-up Operating Instructions
7.
Hold the liner in place while turning the take-up reel in a counter-clockwise direction to
remove slack in the supply liner.
8.
Close the printhead assembly until you hear it click in to place.
9.
Close the printer’s cover.
10.
Close the exit cover.
11.
Press
FEED
to position the supply under the printhead.
Removing a Full Liner Take-Up Roll
Remove the liner take-up when the printer alerts you of a full roll. The liner take-up reel holds
half of a roll of supply. Refer to the
Operator’s Handbook
for additional information.
1.
Open the cover.
2.
Unlock the printhead assembly by turning the retaining latch.
3.
Press down on the exit cover tabs to open the exit cover on the front of the printer.
4.
Use scissors to cut the liner in front of the take-up reel.
5.
Gently pull the full liner take-up core off the reel.
Note:
Place your fingers between the take-up core and printer wall. Gently push the core off
the reel. This eases removal and minimizes the liner telescoping from the reel.
6.
Remove the liner from the take-up core.
7.
Reload supply and continue printing.
C u t L i ne r H ere
