MICRO SD CARD
& RESET BUTTON
Copyright © 2014 AvertX. All rights reserved. Information contained in this document
is subject to change without prior notice. AvertX does its best to provide accurate
information, but cannot be held responsible for typos or mistakes.
31629AC
•
Protect the network cable connection from water damage by running the cord
inside a wall or ceiling, or through conduit.
•
If passing the cord through a wall or ceiling, drill a 3/4”” hole.
•
For outdoor installations, seal any holes in the wall or ceiling with silicone caulk to
protect against water intrusion.
NETWORK CABLE INSTALLATION
When installing your AvertX Night Vision HD Indoor/Outdoor Bullet Camera, it is
important to consider how the network cable attached to the camera is arranged.
1-855-2avertX (1-855-228-3789)
www.avertx.com
If you are using this camera with an AvertX recorder, follow the instructions in the
HDIP recorder user manual to connect to your camera. You can also set up your
camera over your network using an internet browser. Type the IP address of the
camera in the address bar of your internet browser to connect to the camera.
If your internet browser doesn’t install the camera viewer software, check the security
settings or ActiveX controls and plug-in settings. If your internet browser asks for
permission to install the ActiveX control, you must allow the ActiveX control to
continue the installation.
Default IP address:
192.168.0.250
User Name and Password:
The username and password are case sensitive. AvertX strongly recommends chang-
ing the password after the initial setup to prevent unauthorized access to the camera.
Username –
Admin
Password –
1234
CONNECTING TO THE CAMERA
FOCUSING THE CAMERA
•
Your HD90 camera includes a Micro SD card slot
(up to 16GB), which can be used for emergency
video backup. Micro SD card is not included.
•
Press the reset button for 30 seconds to
return the camera to factory default settings, if
necessary.
•
You must remove the cover of the HD90 camera
to access the Micro SD card slot and the Reset
button.
Reset button
Micro SD card slot
1. Remove the screw at the bottom of the
front lens cover.
2. Remove the front lens cover by gently
tilting it up from the bottom.
3. Remove the rubber gasket.
4. Loosen the set screw.
5. Turn the lens to focus your camera.
Set screw
Remove lens cover
Remove
gasket
Turn lens
to focus
Tilt lens cover up to remove
Screw
6. Tighten the set screw.
7. Replace the rubber gasket.
8. Align the positioning pin at the top of the
lens cover with the hole on the camera
body and replace the cover.
9. Replace the screw at the bottom of the
front lens cover.
For optimal image quality, you may need to manually focus your AvertX camera after
it has been installed. This card provides instructions for focusing your AvertX HD90
Night Vision HD Indoor/Outdoor Bullet Camera.
