Avere FXT 2300, Руководство по установке

Страница: 33 / 52

29
Chapter 6. Connecting Power to the FXT Series Edge Filer
This section describes the power connections required for an FXT Series edge filer.
6.1. Connecting Power Cables
Review and verify the precautions and warnings in Chapter 3, Precautions for Product Use on page 13
before connecting the edge filer to a power source.
➣ To connect power cables to an FXT Series edge filer node:
1. Locate the AC power cords in the accessory kit that came in the node’s carton. If you received the
incorrect type of power cords, contact Avere Global Services.
2. Ensure that both power supply units (PSUs) are fully seated in the node.
3. Attach an AC power cord to each PSU AC inlet on the node.
4. Attach the plug of each AC power cord to a power receptacle of the appropriate voltage and capacity.
To take full advantage of PSU redundancy, it is recommended that you attach the AC power
cords to different power branch circuits.
6.2. Powering On the FXT Series Node
➣ To power on the FXT Series node:
1. If required, unlock the node’s front bezel by using the key provided in the accessory kit.
Only the FXT 2x00 Series node requires you to remove the front bezel to access the power
button. The power button on the FXT 2x50 Series, FXT 3xx0 Series, and FXT 4xx0 Series
nodes is accessible regardless of the bezel installation.
2. Remove the bezel by pressing the latch on the right-hand side of the bezel to the left and gently pulling the
bezel, right to left, from the node.
3. Press the power button.
The “Power” LED is illuminated green when power is being supplied normally to the node.
4. If necessary replace the front bezel as follows:
a. Position the bezel with the decorative face outward and the latch to the right.
b. While holding the right side of the bezel away from the node, insert the two pins on the left side of
the bezel into the two holes located on the left-side handle of the node.
c. Press the bezel latch to the left to retract the two locking pins on the right side of the bezel.
d. Position the right side of the bezel so the entire bezel is flush with the node’s front panel.
e. Press the latch firmly to the right until the locking pins on the latch engage the two holes in the right-
side handle of the node. If the pins do not engage fully, adjust the location of the bezel slightly and
press the bezel firmly against the node.
f. Pull on the bezel to ensure that it is properly attached.