Avenview SW-HDM2-T4K-4X4, Руководство по эксплуатации продукта

Страница: 13 / 22

www.avenview.com
Page 10
4.1 WEB GUI (GRAPHICAL USER INTERFACE)
Follow the steps below to access and use the web GUI :
1. Connect the SW-HDM2-T4K TCP/IP port to an active network service like the LAN (local area network) connection with an
RJ-45 terminated CAT5e/6 cable and it will grab an IP address via DHCP .
2. O pen a web browser from a PC/laptop and enter device’s IP address on the web address entry bar then hit enter. If you did not
change the devices IP address to a static one using the PC Software and require the IP address or do not know the IP address; simply
click and hold the 'Menu' button on the front panel for about ~5 seconds and the IP address will show on the front LCM panel.
3. Once the browser has loaded it will load the web GUI where you are able to see 5 tabs; General , Control, EDID, Network and
Upgrade.
GENERAL: The general tab allows
user to see input & output
connection status, toggle power
and beep noise, reboot or factory
reset the unit and save or recall
presets.
CONTROL: The control tab will
able users to switch to different
inputs signals.
EDID: The EDID tab will allow
users for smart EDID
managment.