www.avenview.com
Page 2
2.
RS-232 & TELNET COmmANdS
All commands will be not executed unless followed with a carriage return (0x0d) and commands are case sensitive.
Command
Active
A
1
~A
4
Switch Output A to
1
~
4
B
1
~B
4
Switch Output B to
1
~
4
C
1
~C
4
Switch Output C to
1
~
4
D
1
~D
4
Switch Output D to
1
~
4
AB...
1
~AB...
4
Switch Output A B C D... to
1
~
4
at the same time
Setting IP. SubNet. GateWay (Static IP)
P0
Power OFF
P
1
Power ON
I
1~
I
4
Switch all the Output to
1
~
4
ST
Display the current matrix status and F/W version
RS
System Reset to H4
EM
Setting EDID MODE.
1
-STD 2-TV
UARTBAUD1~4
UARTSW1~4
Switch output’s UART to A~D and allow Matrix to send commands to Receiver’s
connected RS-232 device.
SETIP <IP
>
<SubNet> <GW>
RSTIP
IP Configuration Was Reset To Factory Defaults <DHCP>
IPCONFIG
Display the Current IP Config
UARTBAUD?
Display all the output's UART baud
UARTSW?
Display the UART switching state
STORE 01~04
Store current I/O position (01~04)
PRESET 01~04
Recall the store I/O Position (01~04)
SHOW 01~04
Show current port's I/O position (01~04)
NAME N1 N2
Name the stored port N1(01~04) no more than 8 charactors, N2 (ABCDEFGH)
?
Display all the available commands
Quit
Exit (for telnet only)
UARTSW0
Switch output's UART to MCU. Restoring RS-232 control to the Receiver output back to
Matrix.
Set output A~D’s uart baud rate from 1~6
1: 9600bps
2: 14400bps
3: 19200bps
4: 38400bps
5: 57600bps
6: 115200bps
