TECHNICAL SPECIFICATIONS
Document version:
3.0 - April 15, 2020
Valid for products:
Avee700
Software version 3.0
Connector Bose
™
700 headset
2.5mm four pin audio
Connector AC interface cable
USB C
Bias voltage accepted
9-16VDC
Microphone type
Noise reduction
Microphone output signal
0.7 V RMS @ 1khz / 74dB SPL
Adjustable in 6 steps 20-100%
Maximum level is 1.5V RMS
Minimum level is 0.2V RMS
Headset audio level
Adjustable from headset
Normally adjusted from aircraft
Default volume headset:
Bose
™
700 Battery OK:
The last set audio level will be used.
See Bose
™
700 manual how to set.
Battery empty:
In case the battery on the Bose 700 is empty,
the headset volume will go to maximum
Mono/stereo setting
Mono, automatic or stereo always
Configurable with the Avee BlueLink and
from the Avee add-on.
Stereo detection signal level
0.2V RMS
Adjustable using the Avee BlueLink
Firmware
Upgradeable with the Avee BlueLink
FACTORY SETTING
Microphone output signal
0.7V RMS (step 2)
Mono & stereo setting:
Mono
DISCLAIMER
Avee is an unlicensed third-party accessory and is not affiliated with Bose
™
or
Sony
™
.
Bose
™
or Sony
™
does not approve or endorse the products manufactured by
Avee.
The Avee Aviation Microphone add-on
Setup Instructions & User Guide
Follow the instructions in this user guide to install the Avee add-on to your
headsets.
Step 1:
Using the cleaning wipe supplied, clean the
base of your headsets including the area surrounding
the input jack. Ensure that you remove any residue
that is adhered to the headsets. Let dry.
Step 2:
Remove the adhesive strip protective backing
from the add-on magnetic tape.
The magnetic adhesive tape has
the adhesive side facing the
headset, and four magnets facing
the Avee add-on. This feature
enables the Avee to be easily
detached & attached from the
headset.
Step 3:
Guide the add-on to the base of the left
earpiece and firmly press it in place for
minimum 30 seconds. Once attached, carefully
unplug it to reveal the adhesive magnetic tape
applied to the headsets. Press firmly on the
tape to ensure all edges of the tape have
adhered to the headsets.
