Avdel 74101-12000, Инструкция по эксплуатации

Страница: 24 / 28

24
Other symptoms or failures should be reported to your local Avdel authorised distributor or repair centre.
Tool reverses Worn thrust bearing or thrust washers Replace 10
before Insert Dirty insert threads Change batch of inserts
is placed Worn drive screw Replace 10
Lack of lubrication on drive screw Lubricate drive screw properly
(Standard Nutserts only)
Thrust spring not fitted
Fit thrust spring 10
Clutch torque setting too low Adjust to correct setting 15
Insufficient pressure/volume of air Check air supply/fittings 8
Tool runs slowly Insufficient air pressure Adjust air pressure at base of handle 8
5 -6.3 bar maximum.
Incorrect bore of hose Ensure bore of hose is 6.4mm 8
minimum
Insufficient air volume Ensure there is no restriction in the 8
air supply or connections
Tool not properly lubricated Lubricate as per instructions 12
internally
Tool fails to start Tool not properly lubricated Lubricate then depress trigger 12
several times
Restricted air pressure/volume Ensure there is no restriction in 8
the air supply
Tool runs Push rod too long Replace with one of correct length 19
permanently Insufficient air supply Adjust air pressure/volume 5
in reverse mode
Tool runs Push rods/needle roller missing Replace where necessary 19
permanently Push rod too short Replace 19
in forward mode
Inserts not Torque setting too low Adjust to correct setting 15
pulling up Insufficient air pressure/volume Adjust air pressure/volume 8
Inserts out of grip Select correct insert
Lack of lubrication on insert Change batch of inserts
Lack of lubrication on drive screw Lubricate drive screw correctly
(Standard Nutserts only)
Insert thread restricted
Change Inserts
Drive screw thread worn Replace drive screw 10
Incorrect insert/drive screw Replace with correct insert/drive 10
screw
continued overleaf
F a u l t D i a g n o s i s
S Y M P T O M P O S S I B L E C A U S E R E M E D Y PA G E R E F
S y m p t o m P o s s i b l e C a u s e R e m e d y P a g e R e f