Avdel 73432-02000, Инструкция по эксплуатации

Страница: 5 / 24

5
Specification
Intent of Use
The AV™15 Installation Tool is principally a piston and cylinder assembly. When coupled hydraulically and electrically to
a compatible hydraulic power source and the relevant nose assembly is attached, it is then used to install 1/2” Infalok
®
and 1/2” Avbolt
®
in Industrial Environments.
The placing tool and hydraulic pump unit may only be used in accordance with the operating instructions for placing
Avdel ® fasteners.
Refer to the table below for the list of applicable fasteners and associated nose equipment.
Refer to the datasheets listed in the table for the relevant nose assembly instructions.
FASTENER NOSE ASSEMBLY
NOSE ASSEMBLY
DATASHEET
TYPE SIZE PART NUMBER DIM. ‘A’ DIM. ‘B’ PART NUMBER
AVBOLT ® 1/2”
73432-03100 108 mm 43 mm 07900-00905
73433-03100* 108 mm 43 mm 07900-00905
INFALOK ® 1/2”
73432-03200 107 mm 43 mm 07900-00919
73433-03200* 107 mm 43 mm 07900-00919
*Nose assembly with jaw release.
Refer to the illustration on page 6 for the identification of the nose assembly dimensions ‘A’ and ‘B’.
The safety instructions must be followed at all times.
Placing Tool Specification
SPECIFICATION METRIC IMPERIAL
Force:
Pull at stated pull pressure 80.0 kN 17984.7 lbf
Push Off at stated return pressure 37.0 kN 8317.9 lbf
Pressure:
Pull 510 bar 7397 PSI
Return 200 bar 2901 PSI
Stroke: Piston Stroke 32.0 mm 1.26 in
Weight:
Without nose equipment 4.5 kg 9.9 lb
Noise Level: Less than 80 dB(A)
Vibration: Less than 2.5 m/s 2 8 ft/s 2
Hydraulic Oil: Enerpac ® Hydraulic Oil – HF-95X
Product Range:
Avbolt ® 12.7 mm 1/2 in
Infalok
®
12.7 mm 1/2 in
Additional Features:
Stem Ejection – Front or Rear Rear
Seal Arrangement Twin Lip and Wiper Seals
Hydraulic Bearing Rings Yes – Front and Rear
Protective Handle / Hose Gator Yes
Protective Hose Guard Yes
Hose / Cable Retention Clamps Yes