Avdel 73414-02000, Инструкция по эксплуатации

Страница: 13 / 16

13
Tool fails to operate Inoperative HydraPac Check power supply to HydraPac
Loose or disconnected control cord Check for loose or broken wires
Defective switch assembly Replace switch assembly
Faulty hydraulic hose couplings Replace faulty couplings
Tool leaks hydraulic Depending on what leaks occur, Check and replace 'O' rings
oil defective or worn 'O' rings, loose and back-up rings, or
hydraulic hose connections at tool tighten hydraulic hose
Hydraulic oil Restriction in hydraulic line Check couplings and replace
overheats if necessary
Tool operates Low or erratic hydraulic See HydraPac instruction
erratically and fails pressure supply manual
to install fastener Defective or excessively worn Replace 'O' ring and back-up
properly piston, 'O' ring and back-up rings rings
and back-up rings in tool
Excessive wear or scoring of Check and replace defective
sliding surface of tool parts parts
Pull grooves on Operator not pushing nose Instruct operator in proper
fastener pintail completely onto fastener pintail installation methods
stripped during pull before operating tool
stroke Incorrect fastener length Use correct length fastener
Worn or damaged jaw segments Check and replace jaw set
Metal chips accumulated in pull Clean jaw segments
grooves of jaw segments
Excessive sheet gap Eliminate excessive gap
Collar of Hydraloc Improper tool operation See
fastener not Worn anvil in nose Check and replace anvil
completely swaged
Tool "hang up" on Improper tool operation See
swaged collar Hydrapac in idler mode Switch HydraPac off and
on and restart by
depressing trigger switch
Pintail of fastener Pull grooves on fastener stripped See
fails to break Improper tool operation Instruct operator in correct
tool operation
continued overleaf
2
1
2
2
1
F a u l t D i a g n o s i s
S y m p t o m P o s s i b l e C a u s e R e m e d y P a g e R e f