Avaya WLAN 8100 Series, Справочник, Страница: 223 / 382

Related topics:
Configuring server settings on page 223
Enabling remote services on page 224
Enabling authorization on page 224
Setting authorization privilege levels on page 224
Viewing information on page 225
Configuring server settings
About this task
To add a server, use the following command in Global or Interface Configuration
mode:
tacacs server
The following table describes the parameters for this command.
Table 67: tacas server command parameters
Parameter Description
host <IPaddr> Specifies the IP address of the primary
server you want to add or configure.
key <key> Specifies the secret authentication and
encryption key used for all communications
between the NAS and the server.
The key, also referred to as the shared
secret, must be the same as the one defined
on the server. You are prompted to confirm
the key when you enter it.
Important:
The key parameter is a required
parameter when you create a new server
entry. The parameter is optional when you
are modifying an existing entry.
[secondary host <IPaddr>] Specifies the IP address of the secondary
server. The secondary server is used only if
the primary server does not respond.
[port <port>] Specifies the TCP port for where
port is an integer in the range of 0-65535.
The default port number is 49.
To delete a server, use one of the following commands in Global or Interface
Configuration mode:
no tacacs
default tacacs
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference August 2013 223