4
To insert the PC Card, hold it with the label facing to the right, and
slide it gently into one of the PC Card slots on the processor
module. When inserted properly, the PC Card projects about
1-5/8” (4 cm) from the module.
WARNING:
To initialize the system, you MUST insert the enclosed
PC Card before powering up the system for the first time.
5
Power up the system:
A) Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic case for the
entire length of the board. Do not install the power cord at an angle to the case or with a loop in it.
B) If you have a 5-Slot Carrier, move the carrier’s On/Off switch to the “On” position “(—)”.
6
Check all green lights on the front of the modules. If any lights are out, do the following:
A) If a single light is out, power down the control unit, reseat the module, then power up the control unit.
B) If multiple lights are out, power down the control unit, reseat the leftmost module that has a light out, then
power up the control unit.
C) If the lights are still out, contact your local Authorized Dealer or, in the continental U.S. only, call the Avaya
Customer Care Center at 1 800 628-2888 (for PARTNER ACS).
■
If you are upgrading your system, DO NOT REMOVE THE CARD until you have verified that
the upgrade was successful (approximately 20–40 seconds). While the system upgrades, the
bicolor (red/green) power LED on the processor flashes green and red alternately. When the
upgrade has finished, the power LED becomes steady green. Dial Feature 59 at a display
telephone to verify a successful upgrade. (If no display telephone is available, wait 30
seconds after the LED becomes steady green.) Then proceed to Step 6.
■
If a 1600 DSL module resides in the carrier, the module itself may take from 2 to 7 minutes to
initialize. However, the module should have a steady green LED in the same horizontal plane
as the other modules during initialization.
■
If a T1 module resides in the carrier, the module itself may take up to a minute to initialize.
PFT
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
MODULE
206
PFT
L
I
N
E
S
MODULE
206
PARTNER
3000
