Avaya P333R, Руководство пользователя

Страница: 110 / 270

Chapter 5 CLI – Layer 2
90 Avaya
P333T-PWR User’s Guide
ROUTE HOST TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
127.0.0.1 127.0.0.1 5 2 131 lo0
10.10.10.10 192.168.1.1 7 0 0 se0
------------------------------------------------------------------------
set snmp community
Use the
set snmp community
command to set or modify the switch’s SNMP
community strings.
The syntax for this command is:
set snmp community
<access_type> [community string]
Output Example:
P330-1(super)# set snmp community read-only read
SNMP read-only community string set
set snmp trap
Use the
set snmp trap
commands to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver. First
add the
rcvr_addr
and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}
access type read-only, read-write, or trap
enable Activate SNMP traps
disable Deactivate SNMP traps
all (Optional) Specify all trap types
config (Optional) Specify the ConfigChange trap from the TRAP-MIB.
fault (Optional) Specify the Fault trap from the TRAP-MIB.
rcvr_addr IP address or IP alias of the system to receive SNMP traps