Avaya P118LX, Руководство по установке

Страница: 15 / 20

Chapter 2 Installation
6. Connect P110 switches using the Exoplane cables, as shown in Figure 2. A
switch connects to its upper neighbor through two Exoplane cable, and to its
lower neighbor through another two Exoplane cables. Make sure you securely
fasten the cables to the connectors.
Cabling Requirements:
•
For correct operation, the P110 Exoplane must be fully connected, with all
units powered up. In case units are stacked, the P110 NMA
must be installed
and connected to the Exoplane.
Failure to observe this requirement will cause the P110 units to block all traffic
on attached stations and segments.
•
When using the P114T or P114F in the stack, make sure all switches in the
stack are connected using Exoplane cables. Extra cables can be ordered from
your local Avaya representative.
Figure 2 Rear view of a P110 switch stack, showing how the switches are linked via
the Exoplane cables. A P110 NMA resides in the uppermost switch.
7. Two terminators are supplied with the P110 NMA. Insert the two terminators
into the lowest two connectors at the bottom of the stack, as shown in Figure 2.
8. Turn on the mains power to the stack, by individually switching on each
switch.
9. Connect the cables to the front panel ports.
Notes:
•
If P110 NMA in the stack contains the software version 8.6 or higher (as
specified in the P118 Release Notes) or higher, the stack is now fully
operational
P118 Installation Guide 9