Avaya Media Gateway G350, Руководство по обслуживанию

Страница: 42 / 332

G350 component maintenance
Setting G350 synchronization
42 Maintenance of the Avaya G350 Media Gateway
June 2004
NOTE:
The following command is sent from the SAT CLI, and not from the G350 CLI.
To test for slippage, from the SAT, use the command:
test mo logical 4255 physical 1v4 test 144
The results from the above command are shown in Table 11, TEST RESULTS, on page 42:
If a secondary sync source is similarly provisioned:
Table 10: G350-001# set sync source primary
G350-001# show sync timing
SOURCE MM STATUS FAILURE
Primary V4 Active None
Secondary Not Configured
Local V0 Standby None
Comment: The ACT LED does not change its behavior.
Table 11: TEST RESULTS
Port
Maintenance
Name
Alt. Name
Test No.
Result
Error Code
001V4 MG-DS1 144 PASS
Command successfully completed
Table 12: G350-001# set sync interface secondary v3
G350-001# show sync timing
SOURCE MM STATUS FAILURE
Primary V4 Active None
Secondary V3 Standby None
Local V0 Standby None