Avaya LUPCMALL, Инструкция по установке и эксплуатации, Страница: 61 / 68

[61]
1-Amp BGM: Enabling this feature allows a single amp to provide background music (BGM) and paging throughout the
system (BGM is lost in all zones during a zone page). This feature must be disabled when using a separate BGM amplifier
and a paging amplifier.
All-Call:
System-wide all-call announcements made by dialing 00 can be inhibited.
Clock Set: The real time clock in the PCM is set using a 24-hour time format with this feature.
Clock Synchronization:
Closing the AUX and GND terminals on the PCMCPU will reset the real time clock to whatever
time has been programmed in this feature. Both the time must be set and the feature enabled to use this feature. Setting the
time does not automatically enable the feature. Likewise, inhibiting the feature does not erase the time setting.
Code Call: The PCM has the ability to produce chime code calls into a specific zone group. The zones in the group, type of
code call (using pre-programmed patterns or chiming in response to the digits dialed), and number of plays of the code are
programmable.
Confirmation Tone: Two short tone bursts heard only in the handset to indicate entry to the zone paging system.
Default Timer:
The default timer determines the maximum time a page is in the station access mode. The timer is
programmable in 10 second increments up to 990 seconds ("99"). The timer can also be inhibited by using "00" as the time
length code.
Dialing Time Out: A 15-second dialing timeout is provided to prevent accidental lockouts. This time out can be inhibited.
Emergency Override Tone:
A quick 4-tone burst that proceeds override announcements can be selected.
EM/SC Emergency/Shift Tone: This is an external contact closure triggered tone burst into a specific zone group. The
specific zones in the group, the length of the tone burst, or the type of tone can be programmed.
Night Ring: When activated by either a 90V ring signal or contact closure, the night ring tone sounds into a specific zone
group. The zone group and type of tone can be programmed.
Pre-Announce Tone:
Short tone heard in the zone being paged at the start of the page.
Privacy Beep: A short beep heard every 15 seconds during a conversation with a talk back zone to discourage eavesdropping.
Reset Defaults:
Resets all programming features to original factory defaults.
Setup Tone: Used by the installer to check the operation of the speaker and amplifier system. Produces a system-wide beep
tone to provide an operational check of the paging system. This is only available when the RUN/PROGRAM switch is in the
RUN position and the programming phone is off hook. Hanging up stops the tone.
Time Triggers (1-8): Eight separate time-triggered tones can be programmed into the PCM. A specific zone group can be
programmed for each time-triggered tone, the time of the trigger, as well as the length or type of tone. Time tones can be
inhibited and re-enabled without losing previously set trigger times.
VOX Timer:
The length of a silence interval before the PCM disconnects the page in station mode is set by this feature. It
can be set in 1 second increments from 1-9 seconds. Setting the time length to 0 will inhibit the timer.
Zone Groups: The PCM system allows zones to be grouped and accessed as one. Up to 32 zone groups can be created, each
with up to 99 individual zones in each. Zone group programming sets these groups.
Appendix C: Glossary of
Programmable Features