About the Key Expansion Module
5
IP Key Expansion Module (KEM) User Guide
Setup and assembly
The Avaya IP Deskphone KEM mounts on the right side of an Avaya 2002 IP Deskphone or
Avaya 2004 IP Deskphone as shown in Figure 2. It is secured by snapping into a receptacle on the
back of the IP Phone using the desk-mount bracket and structural baseplate supplied with the
Avaya IP Deskphone KEM.
The Avaya IP Deskphone KEM connects to the Avaya 2002 IP Deskphone or Avaya 2004
IP Deskphone using the Accessory Expansion Module (AEM) port on the IP Phone.
Figure 2
Avaya IP Deskphone KEM connected to Avaya 2002 IP Deskphone
Installing the KEM
Use the following instructions to install an Avaya IP Deskphone KEM:
1
Remove the IP Phone from the stand by pressing the IP Phone tilt handle, and pulling the IP
Phone away from the stand.
2
Place the connecting arm of the Avaya IP Deskphone KEM behind the IP Phone and align the
Avaya IP Deskphone KEM connection plug to the AEM port on the back of the IP Phone.
Note:
For the Avaya 2004 IP Deskphone, you can also adjust the stand angle to
maximum, instead of removing the stand.
Note:
An Avaya 2002 IP Deskphone with the product code NTDU76AB34,
NTDU76BB34, NTDU76AB70, or NTDU76BB70 has shorter connector pins than an
Avaya 2002 IP Deskphone with another product code. If your Avaya 2002 IP Deskphone
has a shorter connector pin, you must detach the ribbon cable connector in the IP Phone
KEM from the retaining clip and press the ribbon cable connector into the header
connector before you attach the Avaya IP Deskphone KEM.
