Avaya G700, Установка и обновление, Страница: 222 / 808

Installing a new G700 without an S8300 using the Gateway Installation Wizard
222 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Administer Communication Manager
!
Important:
Important:
The administration procedures in this section are done on the media server that
is the primary controller for the new G700 you previously installed. This primary
controller may or may not be the S8300 you installed in the G700.
The primary controller for the G700 you are installing must be administered to enable
communication between the primary controller and the G700. The administration differs
somewhat depending on whether the primary controller is an S8300 or the primary controller is
an S8400, S8500, or S8700-series Media Server.
Perform one of the following two administration procedures in this section:
●
Administering an S8300 primary controller
●
Administering an S8400, S8500, or S8700-series primary controller
Administering an S8300 primary controller
!
CAUTION:
CAUTION:
This administration applies only to the primary controller. If the S8300 you
installed is configured as an LSP, do
not perform this administration on it.
Translations are automatically copied to the LSP from the S8300 primary
controller.
Skip this section and go to Administering an S8400, S8500, or S8700-series primary
controller on page 227 if the primary controller is an S8400, S8500, or S8700-series Media
Server.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see
Administrator Guide to Avaya Communication
Manager , 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager , 555-233-504.
!
CAUTION:
CAUTION:
Before continuing, be sure you have saved translations in Communication
Manager.
Begin by resetting the system.
To reset the System
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6 .