Avaya Definity SI, Руководство по обслуживанию, Страница: 2601 / 2968

TRANS-ID (Translation-ID)
Issue 4 May 2002 10-1815 555-233-123
Processor circuit pack replacement
When replacing a processor circuit pack, follow the procedures in Table 10-660 :
■
Standard Reliability:
— Begin the procedure with Step #3.
■
High and Critical Reliability:
— Follow the procedure through once. Work on the standby side first,
then on the active side.
NOTE:
Translations loaded from a duplicated system flash card into a simplex
system, even where one of the translation IDs on the flash card corresponds
to the ID on the processor, results in translation ID mismatch.
Table 10-660. Processor circuit pack replacement procedure
√
Step Description Command Procedure
1. Suppress alarms change
system-
parameters
maintenance Change the
Alarm Origination
to OSS Numbers
field to neither
( Screen -1816 ).
Press Enter to effect the changes.
2. Busyout the standby
PPN busyout
standby-spe
3. Remove the old
processor circuit pack Unlatch the old processor circuit pack
and slide it out of its slot (no
power-down required).
4. Replace the processor
NOTE:
If you replace
the Processor
circuit pack, you
need to get a
new license file.
Slide the replacement processor
circuit pack in the slot and latch
securely.
5. System detects ID
mismatch The system detects the translation ID
mismatch, displays the warning
message, and generates a MAJOR
alarm (TRANS-ID).
6. Release standby PPN release
standby-spe Releases the standby PPN.
Continued on next page