Avaya Definity SI, Руководство по обслуживанию, Страница: 2378 / 2968

Maintenance Object Repair Procedures
555-233-123 10-1592 Issue 4 May 2002
5. The following two patterns may occur when the circuit pack is either in
Active or Standby mode. The best approach to determine the mode of the
circuit pack is to use the status system system technician command.
■
Maintenance running on the Standby circuit pack is indicated by the
following pattern (yellow and green LEDs flashing): LED on 0.1
seconds, off for 0.2 seconds, on for 0.1 seconds, off for 0.4 seconds,
on for 0.4 seconds, off for 0.4 seconds.
■
Green flashing and yellow flashing in a pattern different than the
previously mentioned pattern indicates that maintenance is running
on the Active circuit pack.
Error Log Entries and Test to Clear Values
Table 10-588. Synchronization Error Log Entries
Error Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test synchronization
1 (a)
1
Any None WARNING/
MINOR(j)
2
2 This error type initially raises a Warning alarm. If this error type persists and alarms are not
downgraded on this MO due to the value of set options, then, after a period of time, a Minor or Major
alarm is raised.
OFF None
18 (b) 0 disable sync WARNING OFF enable sync
257 (c)
1
Any None WARNING/
MINOR(j)
2
OFF None
513 (d)
1
Any None WARNING/
MAJOR(j)
2
OFF None
769 (e) None MAJOR/
WARNING
3
3 Major alarms on this MO may be downgraded to Warning alarms based on the value used in the set
options command.
OFF None
1793 (f)
4
4 It may take up to one hour for these SYNC alarms to clear due to “leaky bucket” strategy.
0-50 None MAJOR/
WARNING OFF enable sync
2049 (g) (i)
4
0 None WARNING OFF None
2305 (h) (i)
4
0 None WARNING OFF None