Phase 1 Hardware Replacement
Issue 7 November 2003
2-25
555-233-115
Install the UN332C and Optical Drive
NOTE:
To properly seat a circuit pack, push firmly on the front of the faceplate until
the latch reaches the bottom rail of the carrier. Then close the latch until it is
fully engaged.
1. Insert the UN332C circuit pack into the MSSNET slot in the SPE B carrier.
2. Replace the blank faceplate next to the MSSNET circuit pack.
3. Insert the TN2211 optical drive (
) into the rightmost TAPE DRIVE
slot in the SPE B carrier. It uses only 2 slots.
Figure 2-1.
TN2211 Optical Drive
4. Remove the blank faceplate from Memory Slot 4 and place it over the
leftmost Tape Drive slot.
NOTE:
Make sure the removable media is not write-protected before placing
it into the optical drive. If you can see through the hole, it is write
protected (see
).
Red
Green
Yellow
fpdf2211 KLC 010600
TN2211 OPTICAL DRIVE
