Page 52 - IP Office Integration
Page 52
DECT - Installation Manual
DECT Configuration Software
38HBKD0001SAH – Issue 14 (27th October 2003)
User Configuration
Each user assigned to a DECT handset must be configured and the
Internal
directory set up. Perform the following:
1. From Programs/IP Office, open the
Manager
application. The default
password for Administrator is
Administrator
, however this
must
be
changed as early as possible.
2. Open the Configuration Tree (File/Open). The default password for the
configuration is
password
, however this
must
changed as early as
possible.
3. In the Configuration Tree, open
User
to display all available Users.
4. For each analogue port assigned to a DECT handset, right click in the
User
icon and select
Edit.
5. In
the
User
tab enter both a
Name
and
Full Name.
These names
should be unique to each DECT handset and will represent the
Internal
directory.
6. Select the Voicemail tab and ensure that:
-
When voicemail for the DECT is required that the Voicemail On box
is ticked
-
Where voicemail for the DECT or the DECT is to be slave of a
desktop
phone (
), that the Voicemail On box is empty.
DECT Handset as a Slave of a Desktop Phone
A DECT handset can be made a slave of an IP Office desktop handset.
Perform the following:
1. From Start | Programs | IP Office select
DECT Configuration
(the
CCFP application must not be runniing).
2. You will be given the option to switch off the DECT service. Select
Yes
.
3. The IP Office DECT Configuration menu is displayed.
Enter either the name of
the host IP Office or it's
IP Address
The number of the DECT
handset (identified above) and
the number of the desktop
phone will appear here (e.g.
201 – 203) after
Connect and
configure
menu has been
completed (see below).
Click here to access the
Extension Dialog menu (see
below). When completed,
the number of DECT
handsets available to be
twinned is displayed
Enter the password of the host
IP Office
Tick this box to gain access to
the
Connect and configure
menu and hence enable
twinning (see below).
The password must be that of the IP Office connected to the DECT.
4. Check that either the
Host Name
or
IP Address
is displayed. If not,
enter the IP address of the IP Office.
