Avaya CallPilot 201i, Установка оборудования, Страница: 46 / 134

3. Remove the existing backplane cable, including the I/O filter assembly (NT8D81xx)
and mounting hardware for the left slot as follows:
a. Remove the external cable attached to the outside of the I/O panel.
b. For each of the UP 1, UP 2, and UP 3 cable connectors, push the lock
tab outwards to unlock the cable connection, and then pull the connector
off.
Important:
If you attempt to pull the connector off without pressing the lock tab,
you can pull the connector shroud off the backplane. If this happens,
refer to the adjacent connectors for correct key positioning, and then
replace the connector shroud.
Remove the tie wraps where applicable to free the cable.
c. Remove the connector, I/O filter assembly, and all mounting hardware
from the inside of the I/O panel so the slot is completely vacated.
Retain the mounting hardware (that is, screws, tie wrap base, standoffs,
and so on). You will reuse this hardware to fasten the NTRH3501 cable.
4. Repeat step 3 on page 46 to remove the existing backplane cable for the right slot.
Store the cable, I/O filter assembly, and mounting hardware for this cable with your
Meridian 1 spares. You will not use them with the 201i server.
The following diagram shows an example using slots 3 and 4:
Installing the 201i server in a large Meridian 1 system
46 Avaya CallPilot
®
201i Server Hardware Installation December 2010