Avaya CallPilot 201i, Установка оборудования, Страница: 22 / 134

A built-in Ethernet controller on the 201i server motherboard provides Ethernet
connectivity to the ELAN subnet. The ELAN subnet carries call processing traffic between
the CallPilot server and the Meridian 1 switch or Communication Server 1000 system.
Note:
For more information about the ELAN subnet, see the CallPilot Installation and
Configuration Task List.
You use the 201i server multi I/O cable to establish the connections to the ELAN subnet and
the Avaya server subnet. For more information, see
Multi I/O cable description on page 22.
Network requirements
Appropriate networking equipment must be available for both the Avaya server subnet and
ELAN subnet.
The Avaya server subnet and ELAN subnet must be properly configured for correct CallPilot
operation. To ensure correct configuration, Avaya recommends that you consult a network
specialist.
Important:
For important considerations about using the ELAN subnet in your network, see the CallPilot
Installation and Configuration Task List.
Multi I/O cable description
The multi I/O cable contains four connectors, and is approximately 3 m (10 ft) in length. See
the following diagram:
About the 201i server
22 Avaya CallPilot
®
201i Server Hardware Installation December 2010