13
Commissioning
Connect the Blue Voice to your access point
Making the access point recognisable for other Bluetooth devices
Configure your access point in a way, that it is recognisable for other Bluetooth
devices. Make use of the user manual of your access point.
Connecting (bonding)
Your access point must already be in "Discovery mode".
Blue Voice is switched off.
Press the right softkey for a long period.
Blue Voice starts up. The display shows
No device
or changes between
Search
devices
and
No device
.
Press the "Search all" left softkey.
The display first shows
Search available devices
. The search can last appro-
ximately one minute. The device available or a list of all devices available will then be
displayed.
Select the device if necessary.
Confirm.
"Device details" are displayed:
Press the "Enrolment" right softkey.
...
Enter the PIN of your access point and confirm with the "Enrolment"
right softkey.
The message
Registering with ... successful
appears and Blue Voice
goes into idle state.
i
Note
• Only those Bluetooth devices with the CTP profile are displayed.
• If more than one device is shown, compare the Bluetooth device addresses of the
device details. You will find this number in the documents of your access point.
• If the system search was not successful, you can try again using the "Retry" soft-
key. Ensure that the access point is in Discovery mode.