Avaya 3600 Series, Руководство по установке

Страница: 60 / 78

3600 Series Phone Installation Page 60
15-601082 Issue 06a (21 February 2014) IP Office
4.5 Using the AVPP Menus
The initial connection to the AVPP must be made via a serial connection to establish the AVPP’s IP address. After the IP
address is established, connection to the AVPP can be done via the network using Telnet. It is recommended that the
basic setup actions occur while the serial connection is made.
Connecting via the Serial Port
This method is required for initial access to the AVPP. Once it has been configured with an IP address future access can
be done via Telnet (see below).
1. Using a DB-9 female, null-modem cable, connect the AVPP to the serial port of a terminal or PC.
2. Run a terminal emulation program such as HyperTerminal or use a VT-100 terminal with the following
configuration:
·
Bits per second: 9600
·
Data bits: 8
·
Parity: None
·
Stop bits: 1
·
Flow control: None
3. To display the AVPP login screen, press Enter.
4. Enter the default login admin and default password admin. These are case sensitive. The NetLink SVP-II System
menu is displayed.
Connecting via Telnet
Telnet can only be used after the AVPP’s IP address is configured. Telnet access can be disabled if required through the
Network Configuration menu. Many terminal emulation programs support Telnet connections, alternately a basic
Telnet client can be run within Windows
1. Select Start | Run and enter Telnet.
2. Enter open xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx is the IP address of the AVPP.
3. Enter the login name and password.
4. If accepted, the NetLink SVP-II System menu is displayed.
61
65
61