Avari Fitness A450-255, Руководство пользователя

Страница: 12 / 22

12
OPERATIONAL INSTRUCTIONS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt
can be adjusted by turning the
TENSION KNOB(25).
To increase the load, turn the
TENSION KNOB(25)
clockwise.
To decrease the load, turn the TENSION KNOB(25)
counterclockwise. There are eight levels for the load adjustment.
NOTE:
The safety and integrity designed into the Avari® Magnetic Treadmill can only be maintained when the
Avari® Magnetic Treadmill is regularly examined for damage and wear. Special attention should be
given to the following:
MAINTENANCE
1. Since this is a new machine, you may need some time to get used to walking on the treadmill and to
break it in.
2. If the walking resistance is too high, check the BELT TENSION . Refer to page 11 for instructions to
adjust belt tension.
3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board
under the belt.
1. Adjust the TENSION KNOB(25) and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
2. Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(63) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(63) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the Avari® Magnetic Treadmill
removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the
Avari® Magnetic
Treadmill.
8. Keep your Avari® Magnetic Treadmill clean by wiping it off with an absorbent cloth after use.
9. If the
WALKING BELT(10)
does not move easily, lubricate the
BOARD(9)
under the
WALKING
BELT(10) with silicone lubricant.
Meijer.com